HP Process Resource Manager User's Guide

Command reference
prmanalyze
Appendix A206
-t {summary |
conflict | hourly
| daily | weekly
| monthly}
Abbreviated form:
-t{s|c|h|d
| w | m}
Specifies the report type. Valid report types are:
summary (default)
Provides a high-level view of resource use and is a good starting
point when creating a new PRM configuration.
See also the -1 option.
conflict
Provides a detailed view of resource use and is good for
fine-tuning a PRM configuration.
This report requires a resource_density that is set using the
prmanalyze -d option or defaults to a value specified in the -d
description.
Whenever resource use exceeds the resource_density, a
“conflict” occurs. Each conflict is reported separately, with its
start time, stop time, peak consumption, and a list of the
processes (grouped by sort type) that contributed to the conflict.
This report is generated using averages and assumes that
resource consumption rates remain relatively constant over the
life of the process.
Granularity of the conflict report is to the minute.
hourly
Divides the accounting files into one-hour slices. This report can
help you spot common time-based usage patterns where you
might use PRM to prevent contention. Partial hours at the end
of the accounting files are not reported.
daily, weekly, monthly
These reports provide higher-level views of the same data given
in the hourly report. These reports can help you determine
peaks, overall trends, and usage patterns.
The weekly and monthly reports are most commonly used for
resource planning and billing purposes.
Each report type can be abbreviated using its first letter.
Table A-2 prmanalyze options/parameters (Continued)
Option/parameter Description