HP P9000 Command View Advanced Edition Suite Software 7.3.1-00 CLI Reference Guide

NOTE:
• This command is not available for XP1024/XP128.
• To delete a specific copy pair from a copy group, you must specify pvolserialnum,
pvoldevnum, svolserialnum (or svolsequencenum), and svoldevnum. If you omit all
of these parameters, the system deletes all copy pairs in the specified copy group.
Parameters
Table 107 DeleteReplication command parameters
DescriptionStatusParameter name
Number of the copy groupRequired
replication-
groupid
Serial number of the storage system that contains the primary
volume (P-VOL)
Optional
pvolserialnum
Device number of the P-VOL
For P9500 and XP24000/XP20000:
Specify this parameter as a decimal number or colon-delim-
ited hexadecimal number in the format ww:xx:yy, where
ww is the LDKC number, xx is the CU number, and yy is the
LDEV number. ww is optional. If ww is omitted, LDKC is as-
sumed to be 0.
For XP12000/XP10000/SVS200:
Specify this parameter as a decimal number or colon-delim-
ited hexadecimal number in the format xx:yy, where xx is
the CU number, and yy is the LDEV number.
The execution results are output in decimal.
Optional
pvoldevnum
Serial number of the storage system that contains the S-VOL
If you specify this parameter, specify either svolserialnum or
svolsequencenum. Do not specify both parameters at the same
time. If they are specified at the same time, an error will occur.
Optional
svolserialnum
Sequence number of the storage system that contains the S-VOL
If you specify this parameter, specify either svolserialnum or
svolsequencenum. Do not specify both parameters at the same
time. If they are specified at the same time, an error will occur.
Optional
svolsequen-
cenum
Command reference306