NetBase SQL Shadowing Handbook

____________________________________________________________
ver A0195 QUEST Software, Inc. 2-1
Chapter 2
Installation
Installation Summary
Typically, installation of the software and configuration of each system can be accomplished in
less than 20 minutes per system.
NOTE: This installation process assumes that the part of WSL which is a set of routines
provided by HP has been installed into an XL and that the databases to be shadowed
via SQL exist.
In general, the following steps comprise the installation process:
1. Restore the NetBase software from tape.
2. Stream the installation job.
3. Configure NetBase operational parameters.
4. Define all nodes in the network.
5. Make SQLOUT, SQLIN, and TABLE entries in NBDIR.
6. Run ISQL, enabling Warm Standby Logging.
7. Run SQLUtil, adding additional archive logs.
8. Start SQL shadowing within NBCTRL.
Note: NetBase requires that the Loopback network interface must be configured and activated.
Consult your NS manuals for information on the Loopback network interface.