VISTA Plus for MPE User's Guide

VISTA Plus Demonstration
7-5
Performing the VISTA Plus Demonstration
In the “Capturing Reports” section you were told to run a report capture job stream,
STARTCAP.JOB.NETBASE. You can now start the VISTA Plus program to begin viewing
reports using the following command:
: RUN VISTA.PUB.NETBASE
When you enter this command, the screen below is displayed:
The “REPORTS.ARCHIVE.NETBASE” folder is the one that is created by the report capture job
stream. To open this report folder, do the following:
1. Move your cursor until it is highlighting the line that says “REPORTS.ARCHIVE.NETBASE.”
2. Press F4, Open Folder, or press Enter.