MPE/iX Shell and Utilities Reference Manual, Vol 2

stty(1) MPE/iX Shell and Utilities stty(1)
cs6 Select character size CS6.
cs7 Select character size CS7.
cs8 Select character size CS8.
number Set the input and output baud rates to number.Anumber of zero hangs up
the modem line.
ispeed number
Set the input baud rate to number.Anumber of zero sets the input baud rate
to the same value as the output baud rate.
ospeed number
Set the output baud rate to number.Anumber of zero hangs up the modem
line.
hupcl Hang up the modem line on the last close.
–hupcl Do not hang up the modem line on the last close.
hup Hang up the modem line on the last close.
–hup Do not hang up the modem line on the last close.
cstopb Use two stop bits per character.
–cstopb Use one stop bit per character.
cread Enable the receiver.
–cread Disable the receiver.
clocal Assume a line without modem control.
–clocal Assume a line with modem control.
Input Mode Operands
The valid operands for setting input modes are:
ignbrk Ignore break on input.
–ignbrk Do not ignore break on input.
brkint Signal
INTR on break.
–brkint Do not signal INTR on break.
ignpar Ignore parity errors.
1-576 Commands and Utilities