HP Tru64 UNIX and TruCluster Server Version 5.1B-5 Patch Summary and Release Notes (March 2009)

patches be re-installed after 5.1B-5 update. The CPQIM kit is available at: http://
h30097.www3.hp.com/cma/
The CPQIM patches are available at:
http://h30097.www3.hp.com/cma/patches.html
NOTE: See the section “Insight Manager Components DUMP Core” (page 64) for
information about a potential problem with Insight Management Agents that can occur
after Version 5.1B-5 is installed.
2.2.1.2.1 Some Insight Management Agents Kits May Prevent V5.1B-5 Installation (revised)
Under certain conditions, you will be prevented from installing Version 5.1B-5 if you
are running HP Tru64 UNIX Insight Management Agents Version 3.1 or higher or had
a version of the kit previously installed. Those conditions are as follows:
• Your system contains a pre-Version 5.1B-5 kit and the Insight Management Agents
kit.
In this case, upgrading to this kit gives the following error message:
Patch 28020.00 - SP07 OSFCLINET540 (SSRT5971 SSRT3653 SSRT2384 ...)
./sbin/init.d/snmpd: its origin can not be identified.
This patch will not be installed.
• Your system contains Patch Kit 2, Patch Kit 3, or Patch Kit 4 and the Insight
Management Agents kit was once installed but has since been removed.
In this case, upgrading to Version 5.1B-5 gives the following error message:
Patch 28020.00 - SP07 OSFCLINET540 (SSRT5971 SSRT3653 SSRT2384 ...)
./etc/pmgrd_iorate.config: does not exist on your system,
however, it is in the inventory of installed subsets.
This patch will not be installed.
To work around this problem you will need to run the dupatch baseline process before
installing Version 5.1B-5. The following steps will guide you through the process:
1. Create a backup copy of the /sbin/init.d/snmpd script. For example:
# cp /sbin/init.d/snmpd /tmp
An alternative to backing up this file, in which you manually modify it, is provided
following step 7.
2. Run the Version 5.1B-5 dupatch utility and select Option 5, Patch Baseline
Analysis/Adjustment. For detailed instructions, see the Patch Kit Installation
Instructions .
3. After Phase 5 of the baseline procedure, answer y to the following question:
Do you want to enable the installation of any of these patches? [y/n]: y
2.2 Important Kit Installation and Removal Release Notes 23