Owner manual

AM456-9026A HP VMA SAN Gateway User’s Guide 145
For a list of all commands currently available, press the Tab key twice at the prompt.
In Standard mode, for example, press the Tab key twice to list these commands:
Command Modes
The CLI can be in one of three modes, which determine the set of commands that can be executed.
Commands that are not currently available do not show in help or completion, and generally behave
as if they do not exist.
Standard Mode
When the CLI is launched, it begins in Standard mode. This is the most restrictive mode and only
has commands to query a restricted set of state information. In this mode you cannot take any
actions that would directly affect the system, nor can you change any configuration.
User accounts with the unpriv role are restricted to Standard mode.
Enable Mode
The
enable command moves the CLI to Enable mode. This mode has commands to view all state
information and take certain kinds of actions, such as rebooting the system or configuring some
system parameters, but it excludes commands that configure the cluster. Its commands are a
superset of those in Standard mode. The
disable command moves the CLI from Enable mode
back to Standard mode.
The
exit command (in Enable mode) closes the CLI.
User accounts with the
monitor role can use all Enable mode commands.
show<tab>
Lists options of the show command that can immediately follow the show
keyword.
sh<tab><tab>
Completes the show keyword and lists options of the show command.
s<tab><tab>
Lists all available commands that begin with the letter "s".
> <tab><tab>
cli help show terminal
enable no slogin traceroute
exit ping telnet