User guide
ID 1022-8317, Rev. 2.0
NBL OperationNetBootLoader
Page 3
2. NetBootLoader Operation
The basic function of the NetBootLoader is to configure the CPU module for operation and then
to load and start an operating system. In addition, it provides functionality for controlling the op-
eration of the NetBootLoader itself, for programming images or data to the NBL-Flash(es) and
NAND Flash, remote operation access, accessing TFTP or FTP servers, and acquiring Motor-
ola S-Record images.
2.1 NetBootLoader Control
The NetBootLoader provides various functions for controlling the operation of the
NetBootLoader itself as well as the setting of operational parameters. The following table
provides an overview of available NetBootLoader control functions.
Note ...
In the following sections the command title (CMD TITLE) is expressed in capital
letters and is not the same as the syntax of the command. The command syntax
is always written using small letters.
Table 1: NetBootLoader Control Commands
CMD TITLE ALIAS FUNCTION REMARKS
ABORT - Terminate boot wait
ASSIGN - Assign or display device
assignments
For CPUs with multicore processors
ASSIGNMEM - Assign or display memory
assignments
For CPUs with multicore processors
BL Bootline Set or display bootline Bootline stored in RAM
BW Boot Wait Set or display boot wait time
CBL Change Bootline Set or display a bootline Applies to a specific image or all images in
NBL Flash
DHCP - Dynamically set Ethernet port
parameters
Requires that a DHCP or BOOTP server be
available in the same network as the Net-
BootLoader
EXE Execute Execute config file File source NAND Flash
FDT - Enable creation of FDT
NET - Manually set Ethernet port
parameters
Must be set before attempting to use an
Ethernet port; see also the DHCP command
PF Port Format Set serial port parameters Used for the primary and secondary ports
RS Reset Resets system
RUN - (Loads and) starts image If image is not in the data buffer, it is first
loaded then started