UDS1100 Server Device User Guide

3: Getting Started
UDS2100 User Guide 14
Installing the UDS
Figure 3-1. UDS2100 Connected to Serial Device and Network
To install the unit:
To install the unit, complete the following steps in order. Refer to the numbers in the
previous figure.
1. Connect a serial device to your unit. See 2: Introduction for more information
about what kinds of device attachments the unit supports.
2. Connect an Ethernet cable to the 10/100 port.
3. Supply power to your unit using the power supply that was included in the
packaging.
Note: The required input voltage is 9-30 VDC (center +)
(1.8W maximum power).
4. Supply power to the serial device.
Note: If you encounter a problem, please see 11: Troubleshooting and
Contact Information.