Development Board User's Manual

TABLE 3. Mon12 Monitor Commands

BF <StartAddress> <EndAddress>

[<data>]

Fill memory with data

BR [<Address>]

Set/Display user breakpoints

BULK

Erase entire on-chip EEPROM contents

CALL [<Address>]

Call user subroutine at <Address>

G [<Address>]

Begin/continue execution of user code

HELP

Display the Mon12 command summary

LOAD [P]

Load S-Records into memory, P = Paged S2

MD <StartAddress> [<EndAddress>]

Memory Display Bytes

MM <StartAddress>

Modify Memory Bytes

<CR>

Examine/Modify next location

</> or <=>

Examine/Modify same location

<^> or <->

Examine/Modify previous location

<.>

Exit Modify Memory command

MOVE <StartAddress> <EndAddress>

Move a block of memory

Display all CPU registers

Modify CPU Register Contents

STOPAT <Address>

Trace until address

T [<count>]

Trace <count> instructions

1. Mon12 uses internal RAM space from $600 - $7FF for the D60 and $3E00 - $3FFF for the

DG128 and DP256. DO NOT use this space in your program if debugging under Mon12.

2. Register space is located starting at $0000 for the DG128 and DP256, D60 is at $800.

3. Mon12 will not trace into interrupts. To trace an interrupt service set a breakpoint in the

service routine and then trace.