User's Manual

3b. Bike-to-Bike pair up: On one of the two helmets, press “on” for at least

2 seconds;

4. After a few seconds, the helmets “recognize” each another, a beep is emitted

to signal the pair up was successful and intercom communication is

activated;

5. Turn off both Bluetooth Kits and turn them back on to store the pair up data.

11.2. Intercom function

After carrying out the proper pair up procedure, turn on the two helmets. Intercom

connection will be established automatically (this will take a few seconds. Wait until

you hear the acoustic signal confirming the operation).

If automatic connection is not possible, proceed with the manual connection.

Manual intercom activation

With Bluetooth Kit3 turned on, briefly press “on”.

Manual intercom

deactivation

With Bluetooth Kit3 turned on, briefly press “on”.

Intercom swap: From

“Rider-Pillion Passenger”

to “Bike-to-Bike”

Briefly press “on” and “” at the same time.

11.3. Bike-to-Bike intercom

N-Com Bluetooth Kit3 allows bike-to-bike communication between two Bluetooth Kit3

systems up to a distance of approximately 500 m (in open terrain, with no obstacles).

Note: Bluetooth kit system versions prior to version 3 do not allow this function

except at significantly shorter distances.

Note: The communication range and quality may vary considerably depending on the

presence of obstacles, weather conditions, magnetic fields.

Bike-to-Bike intercom communication differs from the Rider-Pillion Passenger kind for

certain specific characteristics: