User Guide

102-001442-001
August 29, 2001
3
QuickStart Rev 99a44 August 22, 2001
 IP address and domain names (required for connecting to the Internet):
 An IP address
 An IP address of a domain name server
 The name of your domain
 Network board and storage device properties, such as the interrupt and port address
(required if not included in NetWare)
PREPARE THE NETWORK
1 Run NetWare Deployment Manager (NWDEPLOY.EXE), located on the NetWare 6 Operating
System CD.
2 Complete all relevant tasks in the Prepare the Network section.
START THE INSTALLATION
1 Access the NetWare 6 Operating System CD.
 Boot from CD
 Boot from DOS partition, access the CD, and enter INSTALL
Make sure that the CONFIG.SYS file contains the FILES=50 and BUFFERS=30
commands.
2 Select the type of installation.
 Express Installation sets up a server using standard settings.
 Custom Installation lets you specify settings for your environment.
SELECT SETTINGS AND DRIVERS
1 Select regional and server settings.
2 Select the mouse and video type.
3 Select a platform support module and storage adapter.
4 Select a storage device and a network board.
SET UP THE SERVER
1 Create volume SYS:.
2 Name the server.
3 Install the NetWare 6 server file system.
4 Install networking protocols.