Algorithm Manual Revision 4
Table Of Contents
Reverb-2
English Manual – Updated 2018-02-28 23
Reverb-2
The Reverb 2 algorithm initially created for the
TC M5000 compliments most types of source
material, however experience has shown that the
Reverb 2 algorithm is especially good on percus-
sive instruments, as it has a very well-defined
precise buildup. The Reverb 2 algorithm is a Ste-
reo In/Stereo Out Reverb.
The Reverb-2 algorithm occupies:
►
@ Normal Sample Rate: 1/4 DSP Resource
►
@ Double Sample Rate: 1/4 DSP Resource
The inputs and outputs of this algorithm are dis-
tributed as follows:
Input Output
L
E1
E2
E3
E4
L
R R
Reverb-2 algorithm – main page
Reverb-2 algorithm – main page
Main
Decay
Range: 0.3 to 60.0 s
Reverb diffuse field Decay time.
Pre Delay
Range: 0 to 200
Sets the time before the first reflection appears.
Increasing the Pre Delay will change the appar-
ent position and, to some degree, the size of the
room.
Reverb Delay
Range: 0 to 100 ms
Delay time on the Reverb diffuse field only.
Where the Pre Delay parameter sets the Delay
time on the entire algorithm, Early Reflections as
well as diffuse field, the Reverb Delay parameter
works on the diffuse field only.
Hi Cut Freq
Range: 500 Hz to flat
Hi Cut filter, shelving type. Provides an overall
reverb high frequency roll-off (6dB per octave),
for creating a warmer sound. Sets the Cut-off
frequency of the overall Hi Cut filter in 1/3-oc-
tave steps.
Hi Cut Att
Range: -40 to 0.0dB
The attenuation control sets the high frequency
roll determined by Hi Cut Freq.
Levels
Early Level
Range: -100dB to 0dB
The Output level of the Early Reflections. When
Early Level is set to off, the Reverb effect will
consist entirely of Reverb diffuse field.
Reverb Level
Range: off to 0.0dB
Sets the level of the reflection envelope relative
to the Early Reflections in 0.5dB steps. If Reverb
Level is set to off you will hear the initial reflec-
tions only.
In Level
Range: -100dB to 0dB
Sets the Input level of the algorithm.