Installation and Programming Guide

19
Modify a Looping Start Time
Step 1 – Turn the Function dial to the SET PROGRAM position.
Step 2 – Enter the program number (1–8) being modied. Press the to activate the selection.
Step 3 – Press to enter a new loop start time in HH MM format (Hours, Minutes and for PM)
and press to accept.
Step 4 – Press to enter a new loop end time in HH MM format (Hours, Minutes and for PM)
and press to accept.
Step 5 – Press to enter a new loop delay time in HH MM format (Hours, Minutes and for PM)
and press to accept.
Step 6 – Return the Function dial to the Auto Run position to exit SET PROGRAM.
Delete a Looping Start Time
Step 1 – Turn the Function dial to the SET PROGRAM position.
Step 2 – Enter the program number (1–8) being modied. Press the to activate the selection.
Step 3 – Enter and press to clear the looping start time. (The start time and end time are
automatically deleted.)
Step 4 – You must re-enter a start time to reactivate the program. (See Set Program – Program Start Time section.)
Step 5 – Return the Function dial to the Auto Run position to exit SET PROGRAM.