User's Manual

3.4.2 Display Console Set Up
Note: The sensor array must be powered and updating before powering up the console, or the
console will time out searching for the sensors. Power the console last.
Note: WiFi Settings reference 13 STEP.
Make certain the weather station sensor array is at least 3m away from the console and within
30m of the console. If the weather station is too close or two far away, it may not receive a proper signal. If you
have more than one Thermo-hygrometer transmitter, make sure they are all powered up and transmitting on
different channels.
Remove the battery door on the back of the display, as shown in Figure 12. Insert four AAA (alkaline or lithium))
batteries in the back of the display console. The display will beep once and all of the LCD segments will light up
for a few seconds to verify all segments are operating properly.
Note: The character contrast is best from a slightly elevated viewing angle.
Figure 12
Replace the battery door, and fold out the desk stand and place the console in the upright position.
The unit will instantly display indoor temperature, humidity, pressure and time. The wind speed, wind gust,
wind direction, rain, outdoor temperature and humidity will update on the display within a few minutes. Do
not Press any menu buttons until the outside transmitter report in, otherwise the outdoor sensor search mode
will be terminated. When the outdoor transmitter data has been received, the console will automatically
switch to the normal mode from which all further settings can be performed.