Instruction manual

7
1. To attach the neck to the head, insert
the neck into the slot at the bottom of the
head. You will hear a loud ‘click’ sound.
This indicates that the head is securely
xed into the neck.
2. To attach the neck to the body, use a
screwdriver to loosen the long screw
attached to the front of the body. Pull
the long screw out. Insert the neck into
the slot on the body. You will hear a loud
‘click’ sound. This indicates that the neck
is securely xed into the body. Push the
long screw into the hole and tighten the
screw with a screwdriver.
3. To attach the pedals to the body, insert
them into the holes on the sides of the
body. You will hear a loud ‘click’ sound.
This indicates that the pedals are securely
xed into the body.
4. To attach the bouncing seat to the body,
rst unlock the seat peg by moving the
latch to the unlock position and pulling out
the seat peg. Insert the seat into the slot
on the top of the body. Set the seat height
by inserting the peg into the holes in the
seat. The seat has two different height
positions. After inserting the piece into its
proper position, you will hear a click to let
you know the piece is secure.
Assembly Instructions