User's Manual

Wireless Matrix SDT-5000 Installation and User Guide
Doc. 020-331-0002v1.1 18/31
Figure 4. LOGON window
NOTE:
The windows displayed in this section are shown in the Transparent mode for
example purposes. The same selections described below are applicable for all
modes.
The window is displayed for 30 seconds to enter a username and password before the
window will clear. If the window clears, press the Enter key twice again and the window will
be displayed.
4. The Select field is displayed on the second line from the bottom of the window. When
inputting a selection, the number selected will be displayed in the Select field. Type “1” and
press the Enter key. The cursor moves to the Username field.
5. Type “USER” in the Username field. Press the Tab key. The cursor moves to the
Password field.
NOTE:
The manufacturer sets the USER’s default username to “USER” and the
password to “user”. The username and password are case sensitive.
6. Type the default password “user” in the Password field. Press the Enter key. The cursor
moves to the Select field.
NOTE:
The Select field recognizes portions of commands as being unique. This means
instead of typing “SAVE” and pressing the Enter key to save the changed data
type “S” and press the Enter key because the “S” can normally be uniquely
identified with the Save selection.
7. To complete the logon, type “S” (for save) in the Select field and press the Enter key. The
Main Menu window (see figure 5) is displayed.