Installation guide

4-2 BEA Products Installation Guide
The following procedure steps you through the installation program. Use this procedure after you
have started the installation program in console mode, as described in Chapter 2, “Starting the
Installation Program.”
1. At the
Welcome prompt, type next (or n for short) or press Enter to continue with the
installation process.
The BEA Systems License Agreement prompt is displayed.
2. Read the Agreement and indicate your acceptance or rejection of its terms by doing one of the
following at the prompt:
–Type
1 to indicate your agreement with the terms of the license and proceed with the
installation. To review the entire agreement, press Enter or type
Down several times.
Type
Up to scroll back through sections previously displayed.
–Type
2 if you do not agree with the terms of the license. If you type 2, the installation
process terminates.
The
Choose BEA Home directory prompt is displayed.
3. Specify the BEA Home directory that will serve as the central support directory for all BEA
products installed on the target system. For details about the BEA Home directory, see
“Choosing a BEA Home Directory” on page 1-12.
One of the following is displayed on your system:
– If you have existing BEA Home directories on your system, a list of the directories is
displayed, as shown in the following example:
Choose BEA Home Directory:
--------------------------
->1¦* Create a new BEA Home
2¦C:\bea
3¦C:\bea_prod
4¦C:\bea_qa
Enter index number to select OR [Exit][Previous][Next]>
To use an existing BEA Home directory, type the number associated with the desired
BEA Home directory.
To create a new BEA Home directory, type
1 or press Enter.
– If there are no BEA Home directories on your system, or you have selected to create a
new BEA Home, the installation program displays the following prompt: