Use and Care Guide

USE AND CARE SPECIFICATIONS
DESCRIPTION: Ipe Oil
®
Hardwood Deck Finish, by DeckWise
®
, is an oil based product that protects and conditions hardwoods
such as Ipe, Cumaru, Tigerwood, Massaranduba and Mahogany while also maintaining an all-natural appearance. It has been
produced with professional results in mind, providing exceptional penetration, water repellency and U.V. protection.
SHAKE, STIR & MIX WELL • Questions/Comments: [e-mail]
The Ipe Clip
®
Fastener Company, LLC
The Ipe Clip
®
Fastener Company, LLC
Phone: [phone] • Email: [e-mail]
Web: www.DeckWise.com
DeckWise
®
, The Ipe Clip
®
Fastener Company, LLC • 2111 58th Ave. East, Bradenton, FL 34203C • All rights reserved. ©Copyright 2018
The suggestions and technical data for use contained herein are accurate to the best of our knowledge. It is offered in good faith that the
statements of this publication does not constitute any warranty, either implied or expressed, as to the performance of this product. As use and
conditions our products are outside our control, we can only guarantee these products to adhere to our criteria of quality. Our liability, if any,
will certainly be limited to only replacing defective product. All technical information stated is at all times subject to change without prior notice.
MAINTENANCE
NOTE: There is no warranty against color fading, whether expressed
or implied. In order to maintain color, it is advised to do so with a
maintenance plan.
Clean and brighten hardwoods at least once a year with DeckWise
®
Deck & Wood Cleaner Part 1 and DeckWise
®
Deck & Wood Brightener
Part 2 or use the DeckWise
®
Deck Restoration Kit with all the
products and tools needed in one handy package. Apply Ipe Oil
®
on
decking and hardwoods every one to two years in most applications
for desired natural hardwood color. Depending on regional climate
conditions, additional coats may be applied to restore the preferred
natural wood color.
Maintaining a clean deck or hardwood surface between finish
applications is recommended with the use of a mild detergent using a
soft bristle brush, and warm water. Mix the mild detergent in a bucket
of warm water; gently scrub the wood surface with the mixture.
Allow the mixture rest on the surface for roughly 5 minutes, and then
thoroughly rinse the wood surface with water.
CLEANUP
Cleanup & Disposal: Wash rollers, brushes, spray equipment and
steel wool with mineral spirits. Be sure to let air dry out of direct
sunlight before disposal. Lay rags flat to dry out of sunlight or soak
application utensils and any other materials in water immediately after
use. Always keep the oil container closed and sealed when not in use.
WARNING! Rags, steel wool, brushes, rollers and waste soaked
with Ipe Oil
®
may spontaneously combust if improperly piled and
discarded. Immediately after each use, place all waste in a water
filled metal container and seal. Dispose of empty containers and
waste filled containers in accordance with local, state and federal
regulations.
Rev:12/10/2019
250
VOC