HP 3PAR OS 3.1.3 Command Line Interface Reference

Specifies the ID of the system to be started.
<toc_gen_number>
Specifies the table of contents generation number for the system to start with.
<disk_quorum>
Specifies the disk quorum for the system to start with.
RESTRICTIONS
• Access to all domains is required to run this command.
• Use this command only when the system cannot start up normally.
EXAMPLES
The following example starts system mysystem in the new system state:
cli% setsysmgr wipe mysystem systemid
The following example starts the system with the table of contents generation number of 42956,
where 91 is the highest disk quorum displayed:
cli% setsysmgr tocgen 42956 91
The following example displays the start of a system’s recovery process from its IDE disk:
cli% setsysmgr force_iderecovery
NOTES
• If the wipe subcommand is specified, all system data and configuration information, including
customer data and VV layout, are destroyed.
• If the force_iderecovery subcommand is specified, the system can delete data for some
of the unstarted VVs. The system can run the checkvv and checkld commands to make the
VVs and logical disks consistent, thereby resulting in a possible data loss.
326 Set Commands