HP XP7 Continuous Access Synchronous for Mainframe Systems User Guide (TK911-96003)

DescriptionError code
(SSB2)
The secondary system does not support Cnt Ac-S Z.CB1F
In referring to the function bit, the system information reference was abnormally terminated.CB20
In a Pairresync operation, all difference setting was abnormally terminated.CB21
An internal error occurred.CB23
Cnt Ac-S Z is not installed in the secondary system.CB60
The required differential area is not available in the secondary system.CB66
An additional shared memory is not installed in the secondary system.CB67
The required differential area is not available in the primary system.CB68
The number of pairs exceeds the maximum number that can be created in a single consistency group.CB69
The Add Pair operation cannot run because the P-VOL is an external storage system volume.CB6E
The Add Pair operation cannot run because the S-VOL is an external storage system volume.CB6F
The Add Pair operation cannot run because the P-VOL is an external storage system migration volume.CB71
The Add Pair operation cannot run because the S-VOL is an external storage system migration volume.CB73
The device is not recognized correctly.CB75
The Add Pair operation cannot run because the paths are specified per storage system.CB76
The used capacity of the Volume Retention software product on the secondary system exceeds the license
capacity.
CB77
The Add Pair operation cannot run because the specified S-VOL is defined as the command device.CB78
A request for an Add Pair operation was rejected because the specified S-VOL belongs to a different CLPR
than the registered consistency group’s CLPR.
CB7E
The pair cannot be added because the specified S-VOL does not support the time stamp transfer mode.CB9E
The storage system is in internal processing. Try the operation again.CBD7
A pair cannot be created because the specified primary system is one of the following:CBD8
• A journal volume used for Cnt Ac-J Z.
• A Cnt Ac-J Z secondary volume that is in a status other than Suspend.
The pair cannot be added because the specified S-VOL is used for Compatible FlashCopy or Compatible
FlashCopy SE, or is the TSE volume.
CBD9
The Add Pair operation cannot run because the used capacity of the Volume Retention on the secondary
system exceeds the license capacity.
CBDA
A request for an Add Pair operation was received in the Cnt Ac-S Z-Cnt Ac-J Z combination status. However,
the command was rejected because the Mirror ID of Cnt Ac-J Z was 0.
CBDC
In configuring a Cnt Ac-S Z-Cnt Ac-J Z multi-target configuration, a request for a Cnt Ac-S Z Add Pair operation
was rejected because the Cnt Ac-J Z pair was in the process of copying.
CBDD
The Add Pair operation cannot run because the P-VOL is a Thin Provisioning Pool-VOL.CBE2
The Add Pair operation cannot run because the S-VOL is a Thin Provisioning Pool-VOL.CBE3
More than 65,280 pairs cannot be created in one storage system.CBE7
The pair cannot be created because the specified P-VOL is being shredded by Volume Shredder.CBEB
The pair cannot be created because the specified S-VOL is being shredded by Volume Shredder.CBEC
112 Troubleshooting