Using the HP DTC Manager/UX

109
Configuring a DTC to enable a printer
8
9 Verify that the ocd process has been started by looking at the output of the
following command:
ps -ef |grep ocd
10 Enable the DDFA variable in the /etc/rc.config.d/netdaemons file to
ensure that the ocd processes are started correctly each time the system is started.
Configuring a DTC printer for the HP-UX spooler
The DTC printer must be configured for the HP-UX spooler using SAM (System
Administration Manager) or the HP-UX lpadmin command. Refer to the HP-UX
System Administration Tasks Manual for information on the HP-UX printer spooler.
Configuring a printer with SAM
To configure the HP-UX spooler from SAM, follow these steps. They are for an
HP-UX 9.x system on an HP 9000 Series 800 system. The procedure may vary
slightly for different versions of HP-UX.
1 Select the following menu options (starting from the SAM main menu).
a Choose Printers/Plotters.
b In the Printer/Plotter Manager screen, choose:
Actions ➔ Local Printer Plotter
If you are using a character mode terminal, the menubar (F4 Menubar On/
Off) must be on to use the Actions menu.
c Choose Add Printer/Plotter Requiring Nonstandard Device File.
2 Complete the Add Printer screen as follows:
Printer Name: Assign a name to the printer.
Printer Model/Interface: With this field selected, press the Enter key. Choose
the printer model corresponding to your printer from the list of printer models
displayed.
Printer Device File Name: Enter the printer device file that you entered in the
file /etc/ddfa/dp for the DTC printer port. For the device file name in the
example on page 108 you would enter:
/dev/telnet/dtc1b3p2
3 Complete the other fields as required and exit from SAM.