HP P9000 Command View Advanced Edition Suite Software 7.3.1-00 CLI Reference Guide

DescriptionStatusParameter name
Performance monitoring mode.
If you specify this parameter, you must also specify
tiercontrol=enable.
Specifiable values vary, depending on the microcode
version.
If the microcode version is earlier than 70-02-XX-XX/XX:
0: Periodic
If this parameter is omitted, 0 is set.
If the microcode version is 70-02-XX-XX/XX or later:
0: Periodic
1: Continuous
If this parameter is omitted, 1 is set.
Optional
(P9500)
monitoringmode
#1
If you specify threshold values for overprovisioningwarning and overprovisioninglim-
it, two warning levels related to the over-provisioning percent can be issued. For
XP24000/XP20000, these threshold values are specific to and managed by the Device Manager
server.
#2
The over-provisioning percent is the percentage of the total size of all THP/Smart volumes with
respect to the THP/Smart pool size. For example, if the THP pool size is 500 GB and the total
size of all THP volumes is 400 GB, the threshold value will be 80 %.
#3
There must be an interval of at least one hour between the times specified for monitorstarttime
and monitorendtime. The same time cannot be specified for monitorstarttime and
monitorendtime.
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
devnums
Obtain this value from the execution result of the GetStorageArray (subtarget=Logic-
alUnit, lusubinfo=LDEV) command. Execute this command by specifying only the model
and serialnum parameters, LogicalUnit for the subtarget parameter, and LDEV for the
lusubinfo parameter. In the execution result of this command, the devNum value of Logic-
alUnit appears under An instance of LogicalUnit. Use the devNum value of a logical
unit that satisfies the conditions to be used as a pool volume in a THP/Smart pool to specify the
devnums parameter.
Command execution example
In this example, the AddPool command creates a Smart pool whose pool ID is 5 (poolid: 5) in the
storage system (serialnum: 53039, model: P9500). In addition, this command also sets the usage
rate threshold for the Smart pool to 75% (threshold: 75).
CLI Reference Guide 77