Installation Manual

HP Storage Essentials SRM 6.0 Installation Guide 131
b. Change the cimom.mcdata.dontUseSmis property as follows:
cimom.mcdata.dontUseSmis=true
NOTE: The cimom.mcdata.dontUseSmis property exists only in upgrade installations.
If the property does not exist on your system, enter it manually.
To enable SMI-S:
a. Comment out the cimom.useSnmpMcDataProvider property by placing a pound sign
(#) in front of it.
b. Change the cimom.mcdata.dontUseSmis property as follows:
cimom.mcdata.dontUseSmis=false.
1. Click Save.
2. Discover the switch. For instructions, see ”Discovering Elements” on page 113.
NOTE: If you change the discovery settings, when you discover the switch with the new method,
make sure you enter the correct credentials. For example, if you change from SNMP to SMI-S, the
required credentials are different. See the section for the specific discovery method for information
on the credentials to enter.
Excluding McDATA and EMC Connectrix Switches from Discovery
Specific McDATA and Connectrix switches can be excluded from discovery by using system
properties.
To exclude one or more switches from discovery, modify the cimom.mcdata.exclude property.
Set the property cimom.mcdata.exclude to a comma-separated list of Worldwide Names
(WWN) of the McDATA and Connectrix switches you want excluded, as shown in the following
example:
cimom.mcdata.exclude=1000080088A07024,1000080088A0D0B6
The management server excludes the switches with the following WWNs: 1000080088A07024
and 1000080088A0D0B6
If the cimom.mcdata.exclude property is not modified, the management server discovers and
obtains details from all McDATA and Connectrix switches.