HP Tru64 UNIX and TruCluster Server Version 5.1B-5 Patch Summary and Release Notes (March 2009)

NOTE: Because the no-roll procedure automatically reboots the system after deleting
the patches, you cannot use this method to delete this patch kit if doing so returns your
system to a pre-patched state.
Failing to run this script will result in your system being unable to boot normally. If
this occurs, do the following:
1. Boot your system in single-user mode:
>>> boot -fl s
2. Run the script:
# /etc/dn_fix_dat.sh
3. Reboot normally.
If you also need to reverse the version switch as described in “Script Required to Reverse
Version Switch”, run the /etc/dn_fix_dat.sh script after step 5 in that process.
Because the no-roll procedure automatically boots your system, you cannot use that
patch kit removal method if doing so would restore your system to a pre-patched state
Note:
If during the dupatch installation and deletion processes you see a Special Instruction
about running this script, you should ignore that instruction unless your system meets
the requirement described here.
2.2.3 Cluster-Specific Installation and Removal Release Notes
This section provides information you need to be aware of if you are installing or
removing patch kits from a TruCluster Server environment.
2.2.3.1 dupclone Error Message Can Be Ignored
Installing this kit using the dupclone process on systems that do not have all of the
operating system and TruCluster Server base subsets installed may result in a messages
similar to the following to be displayed:
Problem installing:
- Tru64_UNIX_V5.1B:
Patch 27034.00
requires the existence of the following un-installed/un-selected subset(s):
- Tru64_UNIX_V5.1B:
Patch 27023.00
- Tru64_UNIX_V5.1B:
Patch 27050.00
.
30 Kit Installation and Removal