Data Sheet

Page
15
- Connect USB port from PLC to PC.
NOTE:
Ardbox Family uses micro USB cable.
- Open Arduino IDE interface:
- Select Industrial Shields boards -> Ardbox Family
- Select the correct Ardbox Analog Board.
If it is used the latest version of Industrial Shields boards it will appear 4 different Ardbox
Analog boards:
The ones that have to be used for the 103-002-72 Ardbox Analog HF are the following ones:
 Ardbox Analog HF w/ HW RS-485
 Ardbox Analog HF w/ HW RS-232
* HW is the abbreviation of Hardware, so depending on the Hardware Serial that will be used,
it is needed to select one or the other. See section 10 to configure the equipment to work with
RS-232 Hardware Serial or RS-485 Hardware Serial.
If it is not used the RS-232 & RS-485 it is needed to select the board Ardbox Analog HF w/ HW
RS-485. See section 8 to enable the features that are disabled when using RS-485 protocol that
will get enabled as there is no RS-485/RS-232 protocol.