Technical data

22
86100A/B/C
Firmware Release Notes
changing modes
• Measurement limits do not work when restored from saved setups
• Mask test align failure does not cause an error in the queue
• Mask margins not working with CG-GS waveforms
• Markers could be moved outside of the window
• Incorrect max string length reported with remote SYST:DSP command
• Inconsistent behavior when saving a file to a full floppy
• Horizontal Scale/Division setting didn't do anything
• Can't remove unused measurement from measurement results tab
• Binblock download of versus function does not work
• Autoscale resets transducer conversion factors
• Autoscale hung when acquisition stopped before using autoscale
• Autoscale failure on math waveform turns on other waveforms
• :VIEW CGM does not work after BLANk if a measurement command is sent first
• :DISplay:DATa? returns inconsistent color scheme
• :DISK:LOAD returns error 46 if in Oscilloscope mode
• TDR fails vertical calibration if Threshold is set to "Units"
• RZ eye width algorithm seems to place L open too close to mean; modified algorithm for
unsymmetrical edges
• Module Delta Temperature reflects Mainframe temperature, not module
• Module calibration time comes from 2 different sources; problem during daylight savings
time change
• Measurement Limit Test still displays measurement after it's been turned off
• Histogram tab stops displaying histogram data after math function
• Delta Y now only shows value in Measurement Results tab when the units are the same
• Databases dump when switching between RZ & NRZ measurements
• Cannot select CGM as source with :WAVEFORM:SOURCE+B34 command
• Cannot change channel offset for differential TDR channels
• :WAVEFORM:DATA? Returns incorrect values in ASCII mode
• :MEAS:CGRADE:JITTER? Does not return correct values; wasn't using source specified in
:MEAS:SOURCE
• :CHAN#:UNIT:ATT, :CHAN#:UNIT:OFF and :CHAN#:PROBE now blocked when stimulus
is on
A.02.20 Release Notes, August 2, 2001 (Differences from Release
A.02.10)
New Feature List
• Japanese Language Help
• Support for 86106B
• Support for 86109B
• Support for 86102U
Defects Fixed:
• Fixed defect that prevents the mask margins from being enabled when a setup file
containing margin information is loaded.
• Fixed defect that forced users to reload masks after performing an autoscale while running
mask test.
• The acquisition speed while eye measurements are turned on, which had been previously
degraded by a factor of four or five, is now fixed.
• GPIB disk store goes to setup directory instead of specified directory, this is now fixed.
• Resolved a problem with the RZ remote query for contrast ratio which causes the