Technical data

Installation Procedures
Subreflector Assembly
Step 1
Step 2
Step 3
53
Figure 4
Figure 75
Place assembly inside the reflector (on the ground or on the mount) 90˚ elevation position.
Place backup plates behind the reflector and align as shown with holes in reflector.
Assemble angle brackets to reflector with 3/8-16 bolts, lock washers, nuts and backup
plates.
Figure 76
Figure 77
Subreflector Strut
Angle Bracket
Subreflector
Backup Plate
Reflector
Joint Plates
Screw 3 all-threaded rods to the subreflector as shown on Figure 4 below.