Manual Chapter 1

3-34 Options and Hardkey Functions
(1) – documentation details as established in the “Job Definition” section of
the alignment process.
(2) – alignment dimensions as established in the “Job Definition” section.
Also illustrates how the machine is viewed during the alignment job and the
dimension units. This section is not shown in a summary report.
(3) – Foot Pre-Check graphic. This illustrates the last checked foot condi-
tions as saved in the alignment job. FDI or Soft Foot is displayed depending
on the type of Foot Pre-Check method used. See “Foot Pre-Check” on page
5-22 for an explanation of the results.
(4) – Thermal growth allowance graphic in the vertical and horizontal
directions. These are the growths as measured or calculated at the machine
feet; a negative number signifies a shrinkage. This section is not shown in a
summary report.
(5) – sensor readings taken during the alignment job; up to 20 sets are
shown in a detailed report. Only the first and last are shown in a summary report.
(6) – machine moves that are calculated and saved during the alignment
job; up to 20 sets are shown in a detailed report. Since six solutions are
available, the solution on screen when it is left is saved. The “----” signifies
a foot was held stationary during that move. The alignment condition is
also shown in offset and angle. Only the first and last are shown in a summary
report.
(7) – notes documented during the alignment job; up to 40 can be shown.
(8) – Alignment Condition graphics that show how the alignment condition
compares with the tolerances. The top two graphics are the vertical direc-
tion and the bottom two are the horizontal direction. The first graphic in
each direction displays all the machines moves or reading sets; the second
graphic in each direction displays the tolerance curves. Text of the align-
ment condition for each move is listed to the right of the diagram.