Manual Chapter 1

3-18 Options and Hardkey Functions
Set Analyzer Address
This option allows the user to read and set the address in the analyzer. The
analyzer address can be set from 11 to 15 with the default address set to 11.
To read and set the analyzer address select Set Analyzer Address from
under the Addressing Selection menu and press Enter. The following menu
will be displayed:
11
This screen will display the address set in the analyzer. If the address is not
correct or you wish to change the address type in the new address from 11
to 15 using the number keys on the keypad and press Enter to continue to
the Alignment Options menu. If the address is correct then press Enter to
continue back to the Alignment Options menu.
Note
If you enter a number outside the range of 11 to 15 you will get
a warning telling you of the error. If this occurs, press any key
to continue and repeat the procedure.
Review Current Addresses
This option allows the user to review the laser head and analyzer addresses
setup in the analyzer. To review the settings setup in the analyzer, select
Review Current Addresses from under the Addressing Selection menu and
press Enter.