Manual Chapter 5

9-15
Using the Model 8211 and Model 8212 Battery Chargers
Model 821
1 Smart Charger
The Model 8211 provides all battery charging needs and comes with the
system. It is a “smart, drop in” charger for the laser heads; it will also charge
the analyzer when plugged into a cable. The following picture shows both
of the laser heads
and the UltraSpec analyzer being charged.
Charging the Sensor Heads and Analyzer with Model 8211 Charger
To set up the 8211, complete these steps:
1.····Plug the power cord into the power supply.
2. ···Plug the power cord into an AC receptacle.
3. ···Plug the power supply into the 8211 in the top end cap.
At that time, the beeper will sound indicating that power has been applied
to the battery charger. As a test, all LEDs will illuminate for 1.5 seconds.
4. ···Plug the analyzer charging cable into the bottom end cap.
The sensor heads and analyzer can now be charged either individually or,
all at the same time.