CLI Guide

Parameters
seconds The maximum lifetime of LSP in seconds. This value must be
greater than the lsp-refresh-interval command. The
higher the value the longer the LSPs are kept. The range is
from 1 to 65535. The default is 1200.
Defaults 1200 seconds
Command Modes ROUTER ISIS
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage Information
Change the maximum LSP lifetime with this command. The maximum LSP lifetime
must always be greater than the LSP refresh interval.
The seconds parameter enables the router to keep LSPs for the specified length of
time. If the value is higher, the overhead is reduced on slower-speed links.
Related
Commands
• lsp-refresh-interval — set the link-state packet (LSP) refresh interval.
maximum-paths
Allows you to configure the maximum number of equal cost paths allowed in a routing table.
NOTE: Enables you to configure a single system wide value that is common for both IPv4 and IPv6
addresses.
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths command.
998
Intermediate System to Intermediate System (IS-IS)