Command Line Reference Guide

neighbor remote-as
Create and specify the remote peer to the BGP neighbor.
S5000
Syntax
neighbor {ip-address | peer-group-name} remote-as number
To delete a remote AS entry, use the no neighbor {ip-address | peer-group-
name} remote-as number command.
Parameters
ip-address Enter the IP address of the neighbor to enter the remote AS in its
routing table.
peer-group-name Enter the name of the peer group to enter the remote AS into routing
tables of all routers within the peer group.
number Enter a number of the AS. The range is 0 to 65535 (2-byte) or 1 to
4294967295 (4-byte).
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must configure your system to accept 4-byte formats before entering a 4-byte AS Number.
If the number parameter is the same as the AS number used in the router bgp command,
the remote AS entry in the neighbor is considered an internal BGP peer entry.
This command creates a peer and the newly created peer is disabled (Shutdown).
Related
Commands
router bgp – enters ROUTER BGP mode and configures routes in an AS.
bgp four-octet-as-support – enables 4-byte support for the BGP process.
neighbor remove-private-as
Remove private AS numbers from the AS-PATH of outgoing updates.
S5000
Syntax
neighbor {ip-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ip-address | peer-group-name}
remove-private-as command.
Parameters
ip-address Enter the IP address of the neighbor to remove the private AS
numbers.
295