Command Line Reference Guide

neighbor subnet
Enable passive peering so that the members of the peer group are dynamic.
S5000
Syntax
neighbor peer-group-name subnet subnet-number mask
To remove passive peering, use the no neighbor peer-group-name subnet
subnet-number mask command.
Parameters
subnet-number
Enter a subnet number in dotted decimal format (A.B.C.D.) as the
allowable range of addresses included in the Peer group.
To allow all addresses, enter 0.0.0.0/0.
mask Enter a prefix mask in / prefix-length format (/x).
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 9.0(1.3) Introduced on the S5000.
neighbor timers
Set keepalive and hold time timers for a BGP neighbor or a peer group.
S5000
Syntax
neighbor {ip-address | peer-group-name} timers keepalive
holdtime
To return to the default values, use the no neighbor {ip-address | peer-group-
name} timers command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal format.
peer-group-name Enter the name of the peer group to set the timers for all routers
within the peer group.
keepalive Enter a number for the time interval, in seconds, between keepalive
messages sent to the neighbor routers. The range is 1 to 65535. The
default is 60 seconds.
holdtime Enter a number for the time interval, in seconds, between the last
keepalive message and declaring the router dead. The range is 3 to
65535. The default is 180 seconds.
300