Command Line Interface Guide

Introduction 19
Primary CLI Commands
The commands that carry out the functions of Server Administrator are
follows:
• omconfig
• omhelp
• omreport
The omconfig command writes values that you assign to an object's
properties. Specify values for warning thresholds on components or prescribe
action the system must take when a certain warning or failure event occurs.
Also, use the omconfig command to assign specific values to the system's
asset information parameters, such as the purchase price of the system, the
system's asset tag, or the system's location.
The omhelp command displays short text help for CLI commands.
The shorthand equivalent of omhelp is the command for which you want
help followed by -?. For example, to display help for the omreport command,
type one of the following commands:
omhelp omreport
omreport -?
The omreport command displays reports of the management information of
the system.
NOTE: For an overall summary of CLI commands, type omhelp.
Table 1-1 lists the primary CLI commands used by Server Administrator.
This guide contains a section for each primary command.
Table 1-1. CLI Commands and Sections in This Guide
Primary CLI
Command
Section Title Related Sections
omconfig "omconfig: Managing Components
Using the Instrumentation Service"
on page 87
"omconfig system or
servermodule assetinfo: Editing
Cost of Ownership Values" on
page 171
omhelp "Using the omhelp Command" on
page 25