Installation manual

Section 6: Moving Faders
6 - 44 Euphonix CS3000/2000 MixView 3.0 Software Supplement
With Release OFF the fader will remain in automation write mode (punched-in)
after you remove your finger from the cap. The fader is punched-out manually
using the fader punch (attention) key or by interrupting time code. The console
default is Release:ON.
You may have noticed in the previous Touch:OFF example, that when you set
Touch:OFF, Release is also set to OFF if previously enabled. The Release
function is irrelevant and cannot be activated when the Touch option is set
OFF.
[Esc] to the Moving Faders menu as shown, then press [F4] to go to the Slaves
menu.
F3F1 F2 F4
F3F1 F2 F4
With Slaves follow ON, each moving fader slave within a group will move to
show the audio level for that fader. This gives you instant visual feedback of
each slave fader’s DCA fader position relative to the others in that group rather
than relying on multiple fader null LEDs.
Conversely, with Slaves follow OFF, all motorized slave faders will operate in
an identical fashion to non-motorized faders using null LEDs. The console
default is Slaves follow:ON.
One of the most useful Euphonix Moving Fader system features is known as
First Punch Manual. Previously, other moving fader automation systems put all
motorized faders into touch punch-in (write-ready) mode, as soon as the mix
system is turned on. While there is some convenience to allowing automation
data to be written with the first touch of the fader cap, it also opens up the
possibility of accidental punch-in.
The Euphonix automation system has long provided the benefit of Auto
Dynamic™, the selective automation of objects. Objects you wish to remain
un-automated and under manual control, can remain so while others are
automated and under computer control. When automation is first activated
and no automation data has been written, the touch-punch function of all
moving faders is inactive. The first punch-in of any fader is done using the
fader punch/attention key. This allows the operator to take full advantage of
First Punch
Manual
Slaves follow On/Off
If Motors are set OFF, Touch
and Release are also turned
OFF. However, you can then
set Touch ON again,
allowing you to have
Motors:OFF with Touch:ON
for punch-in purposes.
SIDE NOTE:
Slaves follow:ON
Motors:ON Touch Slvs
Moving Faders Menu
Slaves Menu