User's Manual Part 1

User’s Guide Chapter 5 – Command Line Interface

SSH Connection

Make sure that default access status is enabled on the AC before attempting to

connect via SSH. Otherwise no SSH connection will be available.

Connect the Access Controller via LAN or WAN ports using the enclosed UTP cable and start a SSH

session (using an application as PuTTY). For example connect your device via the WAN port and

then make a SSH connection to host IP: 192.168.2.66 (default WAN interface IP).

to the next section for details).

Enter the administrator login settings in the displayed CLI command prompt.

The default administrator login settings:

Password: admin01

Figure 18 – CLI Login

After a successful login command prompt is displayed, the CLI is ready for commands. Press ‘?’ to

get a list of main commands:

Figure 19 – Main CLI Commands

‘?’ will not appear on the screen. While pressing this character, the display changes

to the desired help page. To enter ‘?’ as character type ‘\?’.

Connection

Connection is a category of command that is related to the user’s connection with the device.

A full list of all available connection commands/subcommands and its parameters

is available in the Appendix section: D) CLI Commands and Parameters.

In general, connection usage is as follows:

connection <command> <value>

To get a list of all available commands in the connection category type:

Gemtek Systems Page 40