Software Suite for Oracle Instruction Manual

9.7
Verifying Remote Copy Settings
Recovery Manager for Oracle User’s Guide
where:
◆ <username> is the InServ Storage Server CLI user.
◆ <ss_name> is the system name of the secondary/remote InServ Storage Server, which is
attached to the backup host.
◆ You are note prompted for a password if set up correctly.
3 Verify the Remote Copy ports.
The following is sample output from the showport -rcip command:
4 Verify the Remote Copy secondary/remote groups (datafile group and archive log group).
where:
◆ <group name> is the name of the Remote Copy group which contains all virtual
volumes used by database datafiles.
5 Verify the Remote Copy targets.
cli% showport -rcip
N:S:P State HW Address IP Address Netmask Gateway MTU
0:5:1 ready 0002B3C03DF2 193.1.1.1 255.255.255.0 - 1500
1:5:1 ready 0002B3C03E94 194.1.1.1 255.255.255.0 - 1500
cli% showrcopy groups <group_name>
NOTE: Ensure the group is in the Start state and in Periodic mode.
cli% showrcopy targets <target_name>