Command Reference Guide
◦ loss_sync. Link loss sync.
◦ error. Currently in an error state.
◦ non_participate. Link not participating.
◦ taking_coredump.Coredump in progress.
◦ offline. Link is offline.
◦ fw_dead. Firmware dead.
◦ link_idle_for_reset. Link is idle for reset.
◦ dhcp_in_progress. DHCP is in progress.
◦ pending_reset. Link reset is pending.
◦ unknown. Link state is unknown.
• Node_WWN. The WWN that belongs to the controller node identified in the N:S:P column.
• Port_WWN/HW_Addr. The WWN that belongs to the controller node port identified in the
N:S:P column.
• Type. Indicates the port connection type.
host. Port is connected to hosts. This port can also be used for Remote Copy over IP
(RCIP).
◦
◦ disk. Port is connected to disks.
◦ rcfc. FC port is used for Remote Copy.
◦ peer. FC port is used for data migration.
◦ rcip. IP port is used for Remote Copy.
◦ iscsi. iSCSI port connected to hosts.
◦ free. Port is not connected to hosts or disks.
◦ fcoe. Port is used for Fibre Channel over Ethernet (FCoE).
• Protocol. Indicates the protocol type.
◦ FC Fibre Channel
◦ FCoE Fibre Channel over Ethernet
◦ IP Internet Protocol (Remote Copy)
◦ iSCSI iSCSI
◦ - No mode selected (for CNA ports)
• Label. Configurable, human-readable label identifying the HBA port
showport 443