HP 3PAR Management Console 4.5.1 Software User Guide

DescriptionFieldGroup
The system for which the alert was generated.SystemComponent
The system's serial number.System SN
The system’s node ID.Node ID
The node component for which the alert was generated.Component
The number of times the task has been run.Repeat CountFrequency
The last time the task was run.Last Time
The first time the task was run.First Time
Viewing Port Information
To view the Ports screen:
1. Select Peer Motion in the Manager Pane.
2. Select Ports under Peer Motion Configuration in the Peer Motion tree.
The Ports screen shows the topology between the source and destination system ports, a list pane,
and a detail pane. The port topology area displays the source and destination systems, the host
and peer ports, and the ports connectivity.
The list pane provides the following information:
DescriptionColumn
The port location in Node:Slot:Port format.Position
Indicates whether the port is a peer port.Label
The WWN or MAC address of the connected device.WWN/MAC
The state of the port. See “System and Component Status Icons” (page 507).State
Indicates whether the port is FC, iSCSI, RCIP, or RCFC.Type
Indicates whether the connection mode is Host or Peer.Connection Mode
Indicates whether the connection device type is Host or Peer.Connected Device Type
Name of device that the port is connected to.Connected Device
Port firmware mode setting-Initiator, Target, Peer, or Suspended. Ports in Initiator mode
are connected to drive cages and ports in Target mode export to hosts. Suspended
Mode
268 Using Peer Motion in HP 3PAR Management Console Manager