TR3271 Management Programming Manual

COMMANDS AND RESPONSES
STATUS Command
Bit 10 indicates the subsystem is attempting to connect the
subdevice. This applies to PTP subdevices only.
Bit 11 indicates the subsystem is attempting to disconnect
the subdevice. This applies to PTP subdevices only.
Bit 12 is not used.
Bit 13 is not used.
Bit 14 is for internal use only.
Bit 15 is for internal use only.
ZLAST-ERR is the last error detected on the queried subdevice.
ZIS-PTP is a Boolean variable that specifies whether the
subdevice is a pass-through protocol (PTP) subdevice. The
value of this field can be one of the following:
ZSPI-VAL-TRUE The subdevice is a PTP device.
ZSPI-VAL-FALSE The subdevice is not a PTP device.
ZHIS-SYS-NUM is the number of the system on which the TR3271
subdevice resides. This field applies only to PTP subdevices.
ZHIS-LDEV is the number of the line to which the TR3271
subdevice is subordinate. This field applies only to PTP
subdevices.
ZHIS-SDN is the subdevice number of the TR3271 subdevice.
This field applies only to PTP subdevices.
ZHIS-CU is the controller number of the TR3271 subdevice.
This field applies only to PTP subdevices.
ZHIS-DA is the device address of the TR3271 subdevice. This
field applies only to PTP subdevices.
ZSPI-TKN-DATALIST indicates the beginning of a data list. This
token is described in "SPI Standard Definitions" in Section
5, "Common Definitions," and the Distributed Systems Management
programming Manual .
ZCOM-TKN-OBJNAME specifies the name of the TR3271 line or
subdevice for which information was requested. Unless there is
an error that prevents the STATUS command from being attempted at
all, this token is present in every response record. ZCOM-TKN-
OBJNAME is described in "Data-Communications Standard
Definitions" in Section 5, "Common Definitions," and the
Communications Management Programming Manual .
6-105