HP Netserver LXr Pro NetRAID Installation Guide

17
Creating the Array File Systems
Use the instructions below and Windows NT Disk Administrator to partition, assign drive letters, and format the
shared logical drives.
Reboot System A
Reboot System A so that Windows NT can recognize the logical drives you just created in Defining RAID
Arrays. The system boots and loads Windows NT on System A.
CAUTION You must reboot System A to get accurate information about your shared disks, before
you run Disk Administrator.
Running Windows NT Disk Administrator
To run Windows NT Disk Administrator:
1. From the Start menu, choose Programs|Administrative Tools|Disk Administrator.
2. When prompted, click OK, then Yes.
Disk Administrator loads, scans the disks, and displays a list of the logical disks you identified when you
initialized the arrays using HP NetRAID Assistant. An example display follows:
NOTE Keep in mind, Disk Administrator lists disks in order, beginning with local (non-shared)
disks first, followed by the shared disk arrays.
Disk Administrator, Scanned Logical Disks