DSM/SCM Event Management Programming Manual

File-System Errors
DSM/SCM Event Management Programming Manual—529844-003
B-5
114 %162 X25 network problem - restart failure
115 %163 X25 network problem - reset failure
119 %167 Error code value was too large to fit in 8-bit container
120 %170 Data parity error, or attempt to access a tape whose density is higher
than the switch setting on the tape drive
121 %171 Data overrun error
122 %172 Request aborted due to possible data loss caused by reset of circuit
or due to CIU-to-LIU bus (CLB) sequence error or a DP2 disk
process takeover
123 %173 Subdevice busy
124 %174 Line reset is in progress
130 %202 Illegal address to disk
131 %203 Write check error from disk
132 %204 Seek incomplete from disk
133 %205 Access not ready on disk
134 %206 Address compare error on disk
135 %207 Write protect violation with disk
136 %210 Unit ownership error dual-port disk
137 %211 Controller buffer parity error
138 %212 Interrupt overrun
139 %213 Controller error
140 %214 Modem error (communication link not yet established, modem
failure, momentary loss of carrier, or disconnect)
145 %221 Card reader motion check error
146 %222 Card reader read check error
147 %223 Card reader invalid Hollerith code read
148 %224 Invalid read or write from or to an optical disk
150 %226 End-of-tape marker detected
151 %227 Runaway tape detected, or attempt to access a tape whose density
is lower than the switch setting on the tape drive
152 %230 Unusual end, tape unit went offline, or CP6100 file closed while
requests in progress
153 %231 Tape drive power on
154 %232 BOT detected during backspace files or backspace records
155 %233 Only 9-track magnetic tape allowed
Table B-1. File-System Errors (page 5 of 12)
Decimal
Number
Octal
Number Description