DSM/SCM Event Management Programming Manual

File-System Errors
DSM/SCM Event Management Programming Manual—529844-003
B-6
156 %234 Tape command rejected or TIL protocol violation detected
157 %235 I/O process internal error
158 %236 Invalid function requested for HYPERLINK
159 %237 Device mode wrong for request, or attempt to execute the PUP
PRIMARY command while the tape drive is waiting for a labeled tape
mount
160 %240 Request is invalid for device state
161 %241 Impossible event occurred for line state
162 %242 Operation timed out
163 %243 EOT received or power at auto-call unit is off
164 %244 Disconnect received or data line is occupied (busy)
165 %245 RVI received or data line not occupied after setting call request
166 %246 ENQ received or auto-call unit failed to set “present next digit”
167 %247 EOT received on line bid or “data set status” not set after dialing all
digits
168 %250 NAK received online bid or auto-call unit failed to clear “present next
digit” after “digit present” was set
169 %251 WACK received online bid, auto-call unit set “abandon call and retry”,
station disabled or station not defined
170 %252 No ID sequence received during circuit assurance mode or invalid
MCW entry number on write
171 %253 No response received on bid/poll/select, or reply invalid
172 %254 Reply not proper for protocol
173 %255 Maximum allowable NAKS received (transmission error) or invalid
MCW on WRITE or invalid request ID
174 %256 WACK received or CLB frame aborted
175 %257 Incorrect alternating ACK received or command reject
176 %260 POLL sequence ended with no responder
177 %261 Text overrun (insufficient buffer space for data transfer)
178 %262 No address list specified
179 %263 Application buffer incorrect, control request pending, or autopoll
active
180 %264 Unknown device status received
181 %265 Status receipt currently enabled for subdevice
182 %266 SNALU access method outbound RU error
183 %267 SNA session has ended
Table B-1. File-System Errors (page 6 of 12)
Decimal
Number
Octal
Number Description