OSI/FTAM Programming Reference Manual

FTM Procedures

HP NonStop OSI/FTAM Programming Reference Manual—528611-001

4-138

FTM_TERMINATE_REQ_

This procedure allows you to terminate an association with a remote responder. This

procedure terminates the FTAM regime. For a description of the FTAM regime, see the

OSI/FTAM Programming Guide.

status return value

INT

indicates the outcome of the call. For a list of possible ZAPS-VAL-STATUS-xxx

values, see Table B-1 on page B-2.

cepi input

INT:value

is the connection endpoint identifier (CEPI) used to identify the specific

association. Use the CEPI value returned from the FTM_INITIALIZE_REQ_

procedure for this association. For additional information on using the cepi

parameter, see the OSI/FTAM Programming Guide.

cepi is a required parameter.

tag input

INT(32):value

is for use in nowait mode only. Specify a unique value to identify this instance of

the procedure call. When the operation is complete, the MFM_AWAITIOX_

procedure returns the tag value, allowing your application to match the completion

with the correct instance of the procedure call. For details on the use of the tag

parameter, see the OSI/FTAM Programming Guide.

tag is an optional parameter.

Considerations

•

To complete this procedure call successfully, the association must be in the FTAM

regime.

•

You must issue an MFM_AWAITIOX_ call to complete the nowait I/O operation if

you set the nowait operating mode in the FTM_INITIALIZE_REQ_ call.

status := FTM_TERMINATE_REQ_ ( cepi ! I

, [ tag ] ) ; ! I