OSI/FTAM Programming Reference Manual

APS Procedures
HP NonStop OSI/FTAM Programming Reference Manual—528611-001
F-8
APS_STATUS_
device-name output
INT .EXT:ref:(ZAPS-DDL-FILENAME)
is the complete FTAM device name, including subdevice, of the association for the
CEPI you specified. This parameter is available for the CEPI after an
FTM_INITIALIZE_REQ_ procedure has completed successfully. For more
information about subdevices (SUs), refer to the OSI/FTAM Programming Guide or
the OSI/FTAM and OSI/APLMGR SCF Reference Manual.
error-code output
INT .EXT:ref:1
indicates the current error condition, if any, for this CEPI. For the possible values of
this parameter, see Appendix B, NonStop FTAM Initiator Error Messages.
error-subcode output
INT .EXT:ref:1
is a subcode qualifying error-code. For the possible values of this parameter, see
Appendix B, NonStop FTAM Initiator Error Messages.
service-id output
INT .EXT:ref:1
identifies the service that generated an error condition. For the possible values of
this parameter, see ZAPS-DDL-SERVICE-ID on page A-10. If no error has
occurred, the value is ZAPS-VAL-SERVICE-NOVALUE.
diagnostic-buffer output
INT .EXT:ref:(ZAPS-DDL-DIAG-BUF)
is a diagnostic-message buffer used to analyze errors. This parameter is reserved
for NonStop internal use.
original-error-info output
INT .EXT:ref:(ZAPS-DDL-ORIGINAL-ERROR)
indicates the first detected error. This parameter is intended to be used in problem
diagnosis.
transport-state output
INT .EXT:ref:1
indicates the current transport state, if applicable, for the specified CEPI. This
parameter is not used in NonStop FTAM operations and returns a value of 0.