HP MicroServer Remote Access Card User Manual

4. Install a new Remote Access Card:

• Align the card with the system PCIE slot

• Press the card down to ensure the full connection with the board.

5. Follow the steps of installing the system tray.

6. Connect the VGA cable to the VGA port on the Remote Access Card.

7. Power on the server, it will have BMC functions.

Configuring the IP address

The management processor acquires an IP address and subnet mask using either a dynamic or static

process. When using dynamic IP address, your DHCP server will automatically assign an IP address

for BMC.

Obtain the DHCP IP address, using Rom-Based Setup Utility with the following procedures: