Owner manual

168 HP VMA SAN Gateway User’s Guide AM456-9026A

show files system

Display information regarding bytes and inodes usage of the file systems on the system.

show memory

Display information about system memory utilization.

reload

reload [halt] [noconfirm]

Reboot the system if reload, shut down the system if reload halt.

If there are unsaved changes to the configuration, the user may be prompted as to whether they want

to save these changes (that is, do a

write memory) first before rebooting. The prompt will be

suppressed if confirmation of losing unsaved changes is disabled (with the

no cli default

confirm lose-unsaved

command).

The user may also be prompted to confirm the reload regardless of whether there are unsaved

changes or not. This prompt is contingent on a separate configuration setting, controlled with the

[no] cli default confirm reload command. If both prompts are enabled, and the

configuration was unsaved, the user will be prompted twice.

The

noconfirm parameter suppresses both of these confirmations if it is specified.

reload force

If the system is busy performing another operation requiring the management subsystem (which is

almost any management operation), the regular reload

[halt]command will block until it is

finished. If rebooting the system is urgent, the

reload force command will do it immediately.

This reboots the system, and there is no halt variant. There is also never any confirmation, whether

or not there are any unsaved changes to the configuration.

debug generate dump