Instruction Manual

ITDB-100L Barcode Reader
Page 53
5.10.2 Upgrading the FW
Follow the steps below to upgrade the FW.
Step 1: Click FIRMWARE on the left pane of the setup tool to bring up the Firmware
Upgrade menu (
Figure 5-21).
The user can check the current firmware version from the menu.
Step 2: Click Path to locate the firmware file.
Step 3: Click Upgrade F/W to start updating the firmware.
Figure 5-21: FW Upgrade
Step 4: When the FW upgrade is complete, the ITDB-100L restarts automatically.
Step 5: If the FW upgrade is failed or the ITDB-100L is failed to reboot, the user needs to
put the ITDB-100L into the backup mode and upgrade the device FW in the
backup mode. Refer to Section
5.10.3 on how to enter and exit the backup
mode.