User Guide

MESHTEK-H52E
ilumi solutions, inc. www.ilumisolutions.com http://www.ilumi.co/ P a g e 10 | 13
5.1.3. Conformité aux norms d´IC
Cet appareil est conforme à la(aux) norme(s) RSS sans licence d’Industry Canada. Son utilisation est soumise
aux deux conditions suivantes:
1. Cet appareil ne doit pas causer d’interférences et
2. il doit accepter toutes interférences reçues, y compris celles susceptibles d’avoir des effets indésirables
sur son fonctionnement.
Conformément aux réglementations d’Industry Canada, cet émetteur radio ne peut fonctionner qu’à l’aide
d’une antenne dont le type et le gain maximal (ou minimal) ont été approuvés pour cet émetteur par Industry
Canada. Pour réduire le risque d’interférences avec d’autres utilisateurs, il faut choisir le type d’antenne et son
gain de telle sorte que la puissance isotrope rayonnée équivalente (p.i.r.e) ne soit pas supérieure à celle requise
pour obtenir une communication satisfaisante.
Cet équipement respecte les limites d’exposition aux rayonnements IC RSS-102 définies pour un
environnement non contrôlé. Il doit être installé et utilisé en maintenant une distance minimum de 20 cm entre
le radiateur et votre corps.
5.1.4. OEM RESPONSIBILITIES TO COMPLY WITH FCC AND INDUSTRY CANADA REGULATIONS
The MESHTEK-H52E Module has been certified for integration into products only by OEM integrators under
the following conditions:
This device is granted for use in configurations in which the antennas used for this transmitter must be installed
to provide a separation distance of at least 20cm from all person and not be co-located with any other
transmitters except in accordance with FCC and Industry Canada multi-transmitter product procedures.
As long as the two conditions above are met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC peripheral
requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for certain configurations or co-location
with another transmitter), then the FCC and Industry Canada authorizations are no longer considered valid and
the FCC ID and IC Certification Number cannot be used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a
separate FCC and Industry Canada authorization.
5.1.5. OEM Labeling requirements for end product
For an end product using the MESHTEK-H52E module there must be a label containing, at least, the following
information:
CONTAIN FCC ID: 2AEHU-MESHTEK-H52E
CONTAIN IC: 20059-MESHTEKH52E
The label must be affixed on an exterior surface of the end product such that it will be visible upon inspection
in compliance with the modular approval guidelines developed by the FCC.